Zetor FORTERRA HSX 130 - Running in the Tractor; General Principles of New Tractor Run-In in First 100 Hours of Operation; In First 10 Hours of Operation; From 100 Hours of Operation

General principles of new tractor ru
n
-in in first 100 hours of operatio
n
FCL20S5025
During first 100 hours of operation:
 Load tractor in a normal way, avoid operation with low or maximum engine revolutions
 Avoid operation under partial loading of the engine
 Avoid excessive idle run operation
 Check oil levels in engine often (during this time increased oil consumption is normal)
 Check screw joints in particular in supporting parts of tractor
 Learned insufficiencies to be removed immediately, you will thus prevent subsequent damage or
endangered operation
 Keep the same procedure also after tractor complete overhaul
In first 10 hours of operation
From 100 hours of operation
After drive in completion you can work with tractor without limitations.
 perform run-in in traffic
 tighten fastening nuts of front and rear wheels
including connectionbead / rim with prescribed
torque
FCL20S5026
Recommended
operation
revolutions
1,400 - 2,300
rpm
Idle run revolutions 800 ± 25 rpm
Operation oil
pressure
0.2 - 0.5 MPa
Oil pressure with
idle run revolutions
min. 0.05 MPa
Max. coolant
temperature
110°C
RUNNING IN THE TRACTOR
123