Front drive axle fenders
Front Suspended Drive Axle Fenders
Setting wheel stops with front drive axle
There are two possible designs of the front drive axle
fenders
A - Fenders with fixed brackets.
B - Fenders with swivel brackets where the axis of rotation
corresponds only partially to the axis of rotation of the
front wheel. This design allows you to adjust the greater
steering angle of the front wheels. The fenders are on
adjustable brackets, which can be adjusted laterally and
vertically (by moving the screws (a) to various holes)
according to the type of tires used.
FCL20S5029
The front drive axle fenders are designed with rotating
brackets, for which the axis of rotation only partially
corresponds to the axis of rotation of the front wheel.
This design makes allows setting of greater turning of fron
wheels.
The fenders are hanged on the brackets adjustable (by
moving the bolts (a) into other holes) depending on the
type of tires used.
C18N037
Set the stops always with any wheel track change or tire
replacement with front drive axle.
Wheel stops with front drive axle must be set so that there
would be a distance of at least 50 mm between front drive
axle tires and tractor with full lock and full axle swing
around central pin.
Setting wheel stops with front drive axle check
1. Set full lock to one side and check that the distance
between a tire and the nearest solid point on the tractor is
at least 50 mm. Check both front tires.
2. Turn the steering to full lock to the other side and check
according to point 1.
3. Heave one side of the front axle to the maximum swing
(front axle leans against the bracket) and check according
to point 1 and 2.
4. Hoist the other side of front axle to the maximum swing
(front axle leans against the bracket) and check according
to point 1 and 2.
The setting of stops (A) changes after the release of a nut
(2) and unscrewing or screwing in a screw (1).
After the change in setting wheel stops with
front drive axle, it is always necessary to check their
setting according to points 1 to 4.
FCL20S5030
To Next Page
Loading...
