14
Using the CRANE 2S
① Display screen
• Displays status information and camera
control parameters for the CRANE
2S (see display screen description for
details).
② Stabilizer joystick
• Push the joystick up and down, and
left and right to control the stabilizer
movement (does not work in PhoneGo
mode or Point of View mode).
③ Power button/record button
• Long press the power button for three
seconds to turn the CRANE 2S on or off.
• Press once to start/stop recording.
④ LV button
• Press once to access/exit live view mode
on the DSLR.
⑤ Left selection button
• Press to switch to the previous control
item in the main interface.
• Press to return to the previous menu level
in the menu interface.
• Controls the camera's electronic zoom
when mounted with a Sony camera.
⑥ Right selection button
• Press to switch to the next control item in
the main interface.
• Press to confirm selection in the menu
interface.
• Controls the camera's electronic zoom
when mounted with a Sony camera.
⑦ Photo button
• Half press this button to activate auto
camera focus.
• Full press this button to take a photo.
⑧ Dial
• Turn the dial to adjust camera parameters
in the main interface.
• Rotate the dial to move up and down in
the menu interface.
⑨ Menu button
• Press to access or exit menu options.
⑩ Follow focus wheel
• The dial either controls the rotation of the
electronic follow focus or TransFollow
Focus Motor - you can select one in the
menu.
⑪
M button
• Press the M button and the CRANE 2S
will switch between Pan Following mode
and Locking mode (Pan Following mode
is the default mode after powering on).
• Press the M button twice and the
CRANE 2S will switch between Point of
View mode and Vortex mode. Press the
M button again to return to Pan Following
mode.
• Press the M button thrice and the
CRANE 2S will enter Phone Go mode.
Press the M button again to return to
Pan Following mode.
• Long press the M button and the CRANE
2S will enter or exit Standby mode.
⑫
Trigger button
• Press or press and hold to enter
Following mode (you can select this in
the menu). Press again or release the
button to return to the previous mode.
• Press twice and the motor will return to
the initial point of the current mode (this
will not work in Phone Go mode or Point
of View mode).
• Press thrice to rotate the pan axis
motor 180° . The current mode remains
unchanged (this does not work in
Locking mode).
*For installation instructions for TransMount Follow Focus Motor, refer to the instruction
manual that comes with TransMount Follow Focus Motor.
① When starting the CRANE 2S, hold the camera gently to prevent possible
malfunctions of the CRANE 2S, which may cause it to turn randomly, resulting in
damage to the camera.
② When starting the CRANE 2S, hold the handle or place the CRANE 2S on a desktop.
Shaking the CRANE 2S during startup may cause startup failure; do not leave the
handle suspended in the air.
To Next Page
Loading...
Need help?
General
