28
Calibration and firmware upgrade
① Refer to the figure below for the steps to complete six-side calibration.
After completing the calibration, restart the CRANE 2S and it can be used
normally.
② The six-side calibration operation can be understood simply as making the
six planes of the quick release plate perpendicular to the horizontal plane.
③ Six-side calibration can be performed without mounting a camera.
How to perform six-side calibration
1. Six-side calibration via APP：
According to the method introduced in "APP Operations", please connect the
stabilizer with APP, and enter "Calibration", then conduct the six-side calibration
according to the prompt.
2. Six-side calibration via "Zhiyun Gimbal Tools"
Power on the stabilizer and turn it to standby mode. Connect the Type-C port on
the stabilizer with a computer via a Type-C USB cable. Launch Zhiyun Gimbal
Tools, click "open" on the top and click "calibration" on the bottom. Please conduct
the process according to the following steps. A “ √ ” mark will appear after the
calibration is completed.
3. Six-side calibration via OLED display guide
Power on the stabilizer and enter standby mode, then press menu and rotate the dial
to "calibration" option. Single press Right to confirm the selection, and single press
"yes" to start. Conduct the steps appearing on the stabilizer display screen. After the
calibration is completed, a " √ " mark will appear on the display screen.
To Next Page
Loading...
Need help?
General
