27
Calibration and firmware upgrade
When is Calibration Required
Calibrate the CRANE 2S as needed.
When to calibrate How to calibrate
1. Slight deviation is found in the tilt angle of the camera in level
position after turning on.
2. Slight deviation is found in the roll angle of the camera in level
position after turning on.
3. Frequent small angle correction is found when the camera is
in level position while the stabilizer stays still.
Initialization
1. Slight deviation is found in the level position after the
initialization of the stabilizer.
2. The stabilizer has not been used for a long time.
3. The stabilizer undergoes significant temperature difference in
operation environments.
Six-sided
calibration
Slight deviation is found in the tilt or roll angle of the camera in
level position after initialization and six-side calibration of the
stabilizer.
Fine angle
adjustment
How to initialize
After starting the CRANE 2S and entering standby mode, place the CRANE 2S on a
flat surface and keep the CRANE 2S still for about 30 seconds. The CRANE 2S will
automatically initialize.
To Next Page
Loading...
Need help?
General
