Zhiyun CRANE-M2 User Manual

19
Initialization Method
Turn on the stabilizer and long press the Mode Button to enter into Standby mode. Put
the stabilizer on a flat surface and wait for about 30 seconds. The stabilizer will finish the
initialization process automatically.
Calibration and Firmware Upgrade
When do you need to calibrate the stabilizer?
Please calibrate the stabilizer when necessary.
When How
1. Slight deviation is found in the tilt angle of the camera in level position
after turning on.
2. Slight deviation is found in the roll angle of the camera in level position
after turning on.
3. Frequent small angle correction is found when the camera is in level
position while the stabilizer stays still.
Initializing
the
stabilizer
1. Slight deviation is found in the level position after the initialization of the
stabilizer.
2. The stabilizer has not been used for a long time.
3. The stabilizer undergoes significant temperature difference in operation
environments.
Six-side
calibration
Slight deviation is found in the tilt or roll angle of the camera in level
position after initialization and six-side calibration of the stabilizer.
Fine tuning
the motors

Zhiyun CRANE-M2 Specifications

General

Weight	500g
Tilt Angle Range	310°
Roll Angle Range	324°
Pan Angle Range	360°
Following Deviation in Motion State	±0.05°
Compatible Devices	Smartphones, action cameras, compact cameras
Stabilization	3-Axis
Payload	720g
Battery Type	Built-in lithium-ion battery
Mounting Options	1/4\"-20 Mounting Hole
Operating Voltage	12.6 V
Control Interface	buttons
Follow Modes	POV, Vortex
Battery Runtime	7 hours