ZIEHL SPI1021 User Manual

SPI1021 12570-0701-07 Page
18
/ 24 www.ziehl.de
9.16 Possible indications in display
display mode
8 AL 8 , 8Am 8
Alarm , Alarm 10min mean value
8Err58 …8err98
Error messages (see 11. Error messages and measures)
8Ac 8 , 8tal 8
Alarm counter, cumulative alarm time
8Scn 8 , 8 M 8
Scan mode, 10min mean value
Menu mode / configuration mode
U,, , 8U, 8 ,
8u__ 8 , 8U_ 8
Voltage limit value
UM 8
Limit value 10min mean value
H,, , 8H, 8 ,
8H__ 8 , 8H_ 8 , 8HM 8
Hysteresis (if a limit value is changed, the reset value also shifts; that
means it might be necessary to adapt it)
F,, , 8F, 8 ,
8F__ 8 , 8F_ 8
Frequency limit value
8dal 8, 8dof 8
Response time, Reset time; is always counted down in the display
UonF8
Frequency undervoltage (inhibited frequency protection)
8vsr 8, 8rocf8
Vector surge, ROCOF
8dfdt8, 8 per8
Limit ROCOF, response time in periods (4=sensitive, 50=insensitive)
8stby8
Standby mode, standby-time, standby-counter
8Deon8
Delay Enable On, suppression time when switching on and after opening
the enable input
81 ph 8 , 83 ph 8
Single phase, three-phase vector shift evaluation
8rel 8, 8trel8
Relay, Section switch turn-on time, 8 off8 no feedback contacts
tdon8
Power Up delay, runs once at power up device
mode , 8tran8 , defi8
Mode, Transitory Mode, Definitiv Mode
8ddi 8
Delay display, to calm down the display
Dit 8
Display duration scan mode (each measurement is displayed for this
duration)
8Si 8
Simulation
F , 8U 8
Frequency, voltage
Code , 8Plo 8 , 8vsr8
Code lock / sealing, vector shift
8Pin 8
Pin code (default 504)
Info8
Device information, program change
Fnr 8 , 8snr 8
Firmware version, serial number
h 8
Operating hours
Err 8 , 8del 8
Error counter, delete error counter
8yes 8 , 8no 8
Yes, no query for acknowledgement
Pr
8
Program
8 on8 , 8 oFF8
On, Off

ZIEHL SPI1021 Specifications

General

Brand	ZIEHL
Model	SPI1021
Category	Relays
Language	English