SA40 User Manual
Page | 9 Copyright©2021 ZKTECO CO., LTD. All rights reserved.
3 Basic Concepts
The following lists some basic concepts to help you quickly understand functions and operation methods
of the all-in-one device.
Description of Keys 3.1
Enter the administrator password or directly swipe the administrator card to enter the administrator
settings mode.
Key Description
0 Modify the administrator password or set the administrator card
1 Add a card-based user
2 Add a password-based user
3 Add a card-and-password user
4 Delete a user
5 Delete all users
6 Modify the user password
7 Modify the door opening delay time
8 Restore the default settings
9 Set the door opening password, add a card, or delete a card
Card Categories 3.2
Category Description
Installation card (1) The installation card is the first card that is swiped after initialization.
(2) When the installation card is swiped once, it enters the card adding mode. If
you swipe a user card, this card is added. You can swipe multiple cards
consecutively.
(3) When the installation card is swiped twice, it enters the card deleting mode.
If you swipe a user card, this card is deleted. Yo
u can swipe multiple cards
consecutively.
(4) When the installation card is swiped for eight times, all users are cleared.
(5)
In all modes, if no operation is performed within 10s, it exits the
corresponding mode and enters the idle mode.
Administrator
card
In standby state, shortcut operation methods are as follows:
(1)
When the administrator card is directly swiped once, the access control
device enters the administrator mode.
(2)
When the administrator card is directly swiped twice, the door sensor
switches between the NO and NC modes.
(3) When the addition card is directly wiped, it enters the batch adding card-
To Next Page
Loading...
