SA40 User Manual
Page | 15 Copyright©2021 ZKTECO CO., LTD. All rights reserved.
21. Set Door Sensor Alarm Switch
Press *#administrator password
7
2
0/1 (0: off; 1; on)
For example: *#
1234
7
2
0/1
22. Set Switch for Alarm for Pressing a Key by Mistake
Press *#administrator password
7
8
0/1 (0: off; 1: on)
For example: *#
1234
7
8
0/1
Note:
1) The alarm for pressing a key by mistake is enabled by default. If you enter the administrator password
incorrectly for five consecutive times, within 10s, you can only press keys (the buffer rings) but cannot
swipe the card to open the door. 10s later, you can perform operations.
2) If the number of pressing a key by mistake is less than five times and no operation is performed 1
minute later, the number of pressing a key by mistake allowed is resumed to five times.
23. Restore Default Settings
You can restore the default settings of the access control device while retaining all the user data by using
two methods.
1) Press *#administrator password
8#
0#
For example: *#
1234
8#
0#
2) In standby mode, the shortcut operation method is: directly swipe the deletion card, addition card,
and deletion card in sequence. Then the device is initialized to the default parameter settings.
Note: After the device is initialized successfully, all settings are cleared but the user information is not
cleared.
Default Parameter Settings
General door opening password The default initial value is 8888.
Door opening delay time The value range is 1-60s. The default value is 3s.
Key backlight The default value is normally on.
To Next Page
Loading...
