ZKTeco SA40 - Set Door Opening Delay Time; Set Key Backlight; Set Indicator; Set Door Sensor Mode

SA40 User Manual
Page | 14 Copyright©2021 ZKTECO CO., LTD. All rights reserved.
2) Card-and-password users: Press *#administrator password

6

swipe the card

new password of 4-
6 digits#
For example: *#

1234

6

swipe the card

123456 #
Note: You can perform operations consecutively in administrator state and press * to exit the state.
15. Set Door Opening Delay Time
Press *#administrator password

7

1

enter the delay time#
For example: *#

1234

7

1

3s#
Note: The door opening delay time is 0-60s. The default value is 3s and the maximum value is 60s.
16. Set Key Backlight
Press*#administrator password

7

5

0/1/2 (0: normally off; 1: normally on; 2: the backlight is off when
you touch the key)
For example: *#

1234

7

5

0/1/2
17. Set Indicator
Press *#administrator password

7

6

0/1 (0: off; 1: on)
For example: *#

1234

7

6

0/1
18. Set Door Sensor Mode
Press *#administrator password

7

4

0/1 (0: NC; 1: NO)
For example: *#

1234

7

4

0/1
19. Set Door Sensor Alarm Delay Time
Press *#administrator password

7

7

enter the alarm delay time#
For example: *#

1234

7

7

15#
Note: The door sensor alarm delay time is 0-255s. The default value is 15s.
20. Set Main Alarm Switch
In standby mode, you can enable or disable the door sensor alarm or the alarm for pressing a key by
mistake through shortcut operations.
1) Enable the alarms: Directly swipe the addition card for three times to enable the door sensor alarm and
the alarm for pressing a key by mistake.
2) Disable the alarms: Directly swipe the deletion card for three times to disable the door sensor alarm
and the alarm for pressing a key by mistake.