In the Play mode, a patch is selected and played. When the
2020 is turned on, it goes into the Play mode automatically.
In the Play mode, the following information is shown on the
display.
(1) Group
The currently selected group is shown in the GROUP
field.
(2) Bank number
The currently selected bank number is shown in the
BANK field.
(3) Patch number
The currently selected patch number is indicated by the
pedal LED (1 - 4).
(4) Effect module on/off
The effect module on/off condition in the patch is
indicated by the module cursor LED.
Selecting a Patch
• Turn off the amplifier(s) and set the volume control to
minimum. Then connect the 2020 to the instrument
and amplifier(s).
• Turn on the amplifier(s) and adjust the volume to a
suitable position while playing the instrument. The
2020 is turned on automatically when the cable from
the AC adapter is connected to the 2020.
• Select the desired group with the GROUP key.
In the 2020, patches are divided into the user group for
patches which can be created and altered freely by the user,
and the preset group for factory defined patches where only
the output level can be changed. Choose the group from
which you want to select a patch. With each push of the
GROUP key, the group setting cycles through the following
three settings which are shown on the display.
• U (USER) User group only
• P (PRESET) Preset group only
• U or P (BOTH) User group and preset group
8
Playing a Patch (Use of the Play Mode)
To Next Page
Loading...
Need help?
General
