EasyManuals Logo

Zoom G1 User Manual

Zoom G1
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
- 11 -
Special function start up
1. Special function and how to start up
There are some methods to start up the G1 for service.
All special functions start up the G1 in the following ways using the AC adaptor AD-0006 or
connecting the plug into INPUT connector (J2) when set the battery.
Turn on the G1 holding the key in the following table.
See the following table about Special function.
Function
Keys held down
Test mode
RHYTHM + BANK UPTAP
16 click adjust STORE + RHYTHM
Back up user’s data
STORE + BANK UPTAP
ALL Initialization
STORE
Pre-select UP ([^])
Revision RHYTHM + DOWN ([v])
Version
BANK UPTAP + UP([^])
2Details of special function
Test mode
This startup is used for the function Test.
Refer to page 4.
16 click adjust
Adjust the threshold of 16 click vol. (from 0 click to 15 click)
1) Start up holding the [STORE] key (SW3) and [RHYTHM] key (SW2).
Make sure “1” appears on the 7 segment LED.
2) Turn the Module selector (VR1) clockwise by one detent.
Press the [STORE] key (SW3). *Refer to the figure below.
Make sure “2” appears on the 7 segment LED.
3) Turn the Module selector (VR1) clockwise by one detent.
Press the [STORE] key (SW3).
Repeat this sequence to “DECAY”.
(When “PATCH LEVEL”, 7 segment LED is displayed “3”.
When “COMP/EFX”, 7 segment LED is displayed “4”.
.
.
.
When “REVERB”, press the [STORE] key (SW3), 7 segment LED is displayed “15”.)
Make sure “-14” appears on the 7 segment LED.
4) Turn the Module selector (VR1) anticlockwise by one detent.
Press the [STORE] key (SW3).
Make sure “-13” appears on the 7 segment LED.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zoom G1 and is the answer not in the manual?

Zoom G1 Specifications

General IconGeneral
Simultaneous Effects5
A/D Conversion24-bit
D/A Conversion24-bit
Input Impedance1 MΩ
Output Impedance1 kΩ
Patch Memory40
Weight350g (without batteries)
Inputs1/4" phone jack
Outputs1/4" phone jack
Effects TypesCompressor, Overdrive, Distortion, EQ, Chorus, Flanger, Phaser, Tremolo, Vibrato, Delay, Reverb

Related product manuals