Zoom MS-70CDR+ - Page 13

12 13
PING PONG
DELAY
This delay outputs the delay sound alternately left and right.
TIME Sets the delay time. 1 - 4000
MODE
Sets the delay time range.
When metronome is chosen, the delay time is synchronized to the tempo.
Short,
Long,
REPEAT Adjusts the number of repeats. 0 - 100
MIX Adjusts the amount of effected sound that is mixed with the original sound. 0 - 100
REVERSE
DELAY
This reverse delay is a long delay with a maximum length of 2000 mS.
TIME Sets the delay time. 10 - 2000
MODE
Sets the delay time range.
When metronome is chosen, the delay time is synchronized to the tempo.
Short,
Long,
REPEAT Adjusts the number of repeats. 0 - 100
BAL Adjusts the balance between original and effect sounds. 0 - 100
HIDMP Adjusts the treble attenuation of the delay sound. 0 - 10
VOL Adjusts the volume. 0 - 100
TAIL
When ON, effect sound continues even after effect is turned off. When OFF, effect sound stops
right when effect is turned off.
OFF, ON
MODULATION
DELAY
This delay effect allows the use of modulation.
TIME Sets the delay time. 1 - 2000
MODE
Sets the delay time range.
When metronome is chosen, the delay time is synchronized to the tempo.
Short,
Long,
REPEAT Adjusts the number of repeats. 0 - 100
MIX Adjusts the amount of effected sound that is mixed with the original sound. 0 - 100
RATE Sets the speed of the modulation. 1 - 50
VOL Adjusts the volume. 0 - 100
TAIL
When ON, effect sound continues even after effect is turned off. When OFF, effect sound stops
right when effect is turned off.
OFF, ON
MODULATION
DELAY 2
You can adjust the depth of this modulation delay effect.
TIME Sets the delay time. 1 - 2000
MODE
Sets the delay time range.
When metronome is chosen, the delay time is synchronized to the tempo.
Short,
Long,
REPEAT Adjusts the number of repeats. 0 - 100
MIX Adjusts the amount of effected sound that is mixed with the original sound. 0 - 100
DEPTH Adjust the depth of the modulation. 0 - 100
RATE Sets the speed of the modulation. 1 - 50
VOL Adjusts the volume. 0 - 100
TAIL
When ON, effect sound continues even after effect is turned off. When OFF, effect sound stops
right when effect is turned off.
OFF, ON
DELAY