22 23
MODULATION
REVERB
This reverb generates fluctuating echoes.
PRE DLY Adjusts the delay between input of the original sound and start of the reverb sound. 1 - 100
DECAY Adjusts the duration of the reverb. 1 - 30
TONE Adjusts the tone. 0 - 10
MIX Adjusts the amount of effected sound that is mixed with the original sound. 0 - 100
DEPTH Sets the depth of the modulation. 0 - 100
RATE Sets the speed of the modulation. 1 - 50
VOL Adjusts the volume. 0 - 100
TAIL
When ON, effect sound continues even after effect is turned off. When OFF, effect sound stops
right when effect is turned off.
OFF, ON
LO-FI
REVERB
This rough in-your-face reverb is modeled on the LOFI setting of the TC Electronic HALL OF
FAME.
PRE DLY Adjusts the delay between input of the original sound and start of the reverb sound.
SHORT,
LONG
DECAY Sets the duration of the reverberations. 0 - 100
TONE Adjusts the tone. 0 - 100
MIX Adjusts the volume of the effect. 0 - 100
DRY
When ON, the original sound and the effect sound are mixed and output together. When OFF,
only the effect sound is output.
OFF, ON
TAIL
When ON, effect sound continues even after effect is turned off. The dry sound also continues
to have the same tone as when the effect was on. When OFF, effect sound stops right when
effect is turned off.
OFF, ON
CAVE
REVERB
This effect simulates the reverberations of a cave.
PRE DLY Adjusts the delay between input of the original sound and start of the reverb sound. 0 - 200
DECAY Sets the duration of the reverberations. 0 - 100
TONE Adjusts the tone. 0 - 100
MIX Adjusts the amount of effected sound that is mixed with the original sound. 0 - 100
TAIL
When ON, effect sound continues even after effect is turned off. When OFF, effect sound stops
right when effect is turned off.
OFF, ON
REVERSE
REVERB
This effect, which is modeled on the DigiTech RV-7 (Lexicon) Reverse setting, sounds like
reverb in reverse.
DECAY Sets the duration of the reverberations. 0 - 100
TONE Adjusts the tone. 0 - 100
DRY
When ON, the original sound and the effect sound are mixed and output together. When OFF,
only the effect sound is output.
OFF, ON
MIX Adjusts the amount of effected sound that is mixed with the original sound. 0 - 100
TAIL
When ON, effect sound continues even after effect is turned off. When OFF, effect sound stops
right when effect is turned off.
OFF, ON
ECHO
REVERB
This effect can generate gorgeous echoes.
PRE DLY Adjusts the delay between input of the original sound and start of the reverb sound. 0 - 200
DECAY Sets the duration of the reverberations. 0 - 100
TONE Adjusts the tone. 0 - 100
MIX Adjusts the amount of effected sound that is mixed with the original sound. 0 - 100
OUTPUT Sets output to mono or stereo.
MONO,
STEREO
TAIL
When ON, effect sound continues even after effect is turned off. The dry sound also continues
to have the same tone as when the effect was on. When OFF, effect sound stops right when
effect is turned off.
OFF, ON
REVERB
To Next Page
Loading...
