22 23
TREMOLO
REVERB
This effect combines tremolo with just the reverb sound like the Eventide Space
TremoloVerb.
PRE DLY Adjusts the delay between input of the original sound and start of the reverb sound. 0 - 500
DECAY Sets the duration of the reverberations. 0 - 100
SIZE Adjusts the size of the reverb space. 0 - 100
MIX Adjusts the amount of effected sound that is mixed with the original sound. 0 - 100
WAVE Sets the modulation waveform.
SINE, TRI,
PEAK, RNDM,
RAMP, SQR
DEPTH
Sets the depth of modulation. Also sets whether the modulation is mono (MN0–99) or stereo
(ST0–99) .
MN0 - ST99
RATE Sets modulation speed. 1.0 - 20.0
LO Adjusts volume of low frequencies. -100 - 100
HI Adjusts volume of high frequencies. -100 - 100
HOLY
REVERB
This effect combines reverb and flanger in a model of an Electro-Harmonix Holy Grail set to
FLERB.
MIX Adjusts the amount of effected sound that is mixed with the original sound. 0 - 100
TAIL
When ON, effect sound continues even after effect is turned off. When OFF, effect sound stops
right when effect is turned off.
OFF, ON
DYNAMIC
REVERB
This reverb, which is modeled on the TC Electronic NOVA REVERB, changes volume
according to the dynamics of the input sound.
PRE DLY Adjusts the delay between input of the original sound and start of the reverb sound. 0 - 100
DECAY Sets the duration of the reverberations. 0 - 100
SENSE Adjusts the sensitivity of the effect. -100 - 100
MIX Adjusts the amount of effected sound that is mixed with the original sound. 0 - 100
COLOR Adjusts the tone. 0 - 100
TAIL
When ON, effect sound continues even after effect is turned off. When OFF, effect sound stops
right when effect is turned off.
OFF, ON
SHIMMER
REVERB
Modeling the Strymon blueSky in Shimmer mode, this effect adds pitch-shifting and delay
to reverb.
PRE DLY Adjusts the delay between input of the original sound and start of the reverb sound. 1 - 100
DECAY Sets the duration of the reverberations. 0 - 100
MIX Adjusts the amount of effected sound that is mixed with the original sound. 0 - 100
TAIL
When ON, effect sound continues even after effect is turned off. When OFF, effect sound stops
right when effect is turned off.
OFF, ON
LO-DMP Adjusts the amount that the low frequencies of the reverb sound are reduced. 0 - 100
HI-DMP Adjusts the amount that the high frequencies of the reverb sound are reduced. 0 - 100
SHIMMER
REVERB+
The pitch of the reverberation sound rises continuously in this magical reverb.
PRE DLY Adjusts the delay between input of the original sound and start of the reverb sound. 1 - 200
DECAY Sets the duration of the reverberations. 0 - 100
MIX Adjusts the amount of effected sound that is mixed with the original sound. 0 - 100
TAIL
When ON, effect sound continues even after effect is turned off. When OFF, effect sound stops
right when effect is turned off.
OFF, ON
LO-DMP Adjusts the amount that the low frequencies of the reverb sound are reduced. 0 - 100
HI-DMP Adjusts the amount that the high frequencies of the reverb sound are reduced. 0 - 100
REVERB
To Next Page
Loading...
