Zoom Sampletrak ST-224 - Pad Play Mode Operation; Setting Pad Playback Parameters

31
Pad Play Mode Operation
The [PAD FUNCTION] LED flashes.
(Parameter names are printed at the top right of the pads.) The [PAD
FUNCTION] LED and the LED of the selected pad light up, and the
current setting of that parameter is shown on the display. For a
detailed explanation of parameters, see page 32.
For some parameters, the [LOOP/MARK] pad can also be used to
specify a setting (
➔
p. 32).
The change is made and the unit reverts to the pad play mode.
The playback parameters such as level, tuning, playback position, etc. can be set individually for each
pad.
BANK
3
BANK
2
BANK
SONG
PAD
1
FUNCTION
PAD ASSIGN
CAPACITY ERASE OPTIMIZE
PLAY/STOP RECORD
RE-SAMPLE GRADE
MONO
STEREO
SAMPLING
EDIT 2
VOLUME/BASS
EXCITER
TREMOLO
AUTO PAN
LO-FI EFFECT
EXTREME EQ
COMPRESSOR
RESONANCE
HIGH-PASS
LOW- PASS
DISTORTION
RING MODULATOR
PITCH SHIFTER
DIMENSION
CHORUS
PHASER
FLANGER
STEP CRY
DELAY
REVERB
TIME STRETCH
SCRATCH
EFFECT
ON/OFF
PAD ENABLE
A
B
EFFECT SYNC
EDIT 1
LOOP/MARK
4
SHIFT
OFFSET
6
SWING
PANNING
8
MIDI
TRIGGER/GATE
2
QUANTIZE
TUNING
SOURCE
SOURCE MIX
5
PRE COUNT
END POINT
3
TIME SIG
START POINT
1
BAR LENGTH
LEVEL
7
CLICK VOLUME
REVERSE
COPY DELETE
BACKUP
EXIT
SPECIAL
LOAD SAVE
INTERNAL/DATA CARD
+ –
AUTO SYNC
PLAYLIST
TAP
BPM
SONG
PLAY/STOPREC
BPM/ VALUE
MEASURE SAMPLE/SONGBEAT
SONG
PAD
FUNCTION
1
BAR LENGTH
LEVEL
SONG
PAD
FUNCTION
+–
EDIT 1
[EDIT 1]
wheel
[–] [+] keys
Parameter setting value
BPM/ VALUE
MEASURE SAMPLE/SONGBEAT
Press the [PAD FUNCTION] key.
1
STEP
Press one of pads 1 - 8 or the [SOURCE] pad to select the parameter to change.
2
STEP
Press the pad whose parameter you want to edit.
3
STEP
Use the [-] [+] keys or the [EDIT 1] wheel to change the setting.
4
STEP
Press the [PAD FUNCTION] key again.
5
STEP
Setting the Playback Parameters for Each Pad
Pads 1 – 8