Zoom Sampletrak ST-224 - Using Internal Effects; Effect Types List and Parameters

46
Using the Internal Effects
This section lists all effect types with their parameters which can be adjusted using the [EDIT 1] wheel and
[EDIT 2] knob. The list also shows which parameters can be synchronized to effect BPM.
EDIT 1 = parameter can be adjusted with [EDIT 1] wheel
EDIT 2 = parameter can be adjusted with [EDIT 2] knob
SYNC = parameter can be synchronized to effect BPM
Effect Types
EDIT 1EFFECT TYPE BANK EDIT 2 SYNC Description
TIME
STRETCH
A amount tone –
SCRATCH B speed tone –
DELAY A time
feedback
mix &
time
REVERB B time mix –
FLANGER A rate
feedback
rate
STEP CRY B
rate &
reso &
mod-
wave
sens
rate
CHORUS A rate mix –
PHASER B rate rate
PITCH SHIFTER
A pitch tone –
DIMENSION B
rise
level
tone –
resonance
This effect stretches or compresses the sample duration without
changing the pitch. The [EDIT 1] wheel adjusts the duration (amount),
and the [EDIT 2] knob the sound quality (tone). This effect type cannot
be used with the [SOURCE] pad.
This effect stretches or compresses the sample duration and also changes
the pitch, depending on the stretch or compression ratio. The [EDIT 1]
wheel adjusts the duration (speed), and the [EDIT 2] knob the sound
quality (tone).
This delay type effect creates an echo. The [EDIT 1] wheel adjusts the
delay time (time: max. 505 ms), and the [EDIT 2] knob the number of
repeats (feedback) and the mix amount (mix). When the [EFFECT
SYNC] key is set to ON, the delay time parameter is synchronized to the
effect BPM.
This effect adds reverberation to the sound. The [EDIT 1] wheel adjusts
the reverb time (time), and the [EDIT 2] knob the mix amount (mix).
This is a stereo flanger effect. The [EDIT 1] wheel adjusts the flanger
fluctuation speed (rate), and the [EDIT 2] knob the feedback intensity
(feedback) and the mix amount (mix). When the [EFFECT SYNC] key
is set to ON, the fluctuation cycle is synchronized to the effect BPM.
This is a special effect that uses filters to lend a distinct, stair-like
character to the sound. The [EDIT 1] wheel adjusts the sample & hold
speed (rate) and the filter resonance (reso) and modulation waveform
balance (mod-wave). The [EDIT 2] knob adjusts the effect sensitivity
(sens). When the [EFFECT SYNC] key is set to ON, the sample & hold
cycle is synchronized to the effect BPM. Turning the wheel forward
intensifies the cry effect and turning it backward increases the step
effect.
This is a stereo chorus effect with width and depth. The [EDIT 1] wheel
adjusts the chorus speed (rate), and the [EDIT 2] knob the mix amount
(mix).
This effect adds a phase-shifted component to the original sound,
resulting in a pulsating character. The [EDIT 1] wheel adjusts the
pulsing speed (rate), and the [EDIT 2] knob the resonance (resonance).
When the [EFFECT SYNC] key is set to ON, the resonance is
synchronized to the effect BPM.
Pitch-shifter with a +-1 octave range. The [EDIT 1] wheel adjusts the
pitch shift amount (pitch), and the [EDIT 2] knob the sound quality
(tone).
This effect produces a spatial broadening of the sound. The [EDIT 1]
wheel adjusts the effect intensity (rise level), and the [EDIT 2] knob the
sound quality (tone).