EasyManua.ls Logo

Zoom Sampletrak ST-224 - Creating Songs; Playing Recorded Songs

Zoom Sampletrak ST-224
76 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The [SONG PLAY/STOP] LED lights up and playback of the song
starts at the beginning.
Also during playback of a song, you can hit pads to play them
manually. However, the maximum number of simultaneous
sounds may not be exceeded.
Effect operations are not recorded in the song.
Pressing the [SONG PLAY/STOP] key while holding down the
[LOOP/MARK] pad causes the song to be repeated.
The [SONG PLAY/STOP] LED goes out.
The playback start position is indicated on the display, using the
number of bars.
The number of bars shown on the display changes according to the
[-] [+] key operation.
You can also use the [EDIT 1] wheel instead of the [-] [+] keys.
The new start point is set. Song recording and playback can be
carried out from this point.
HINTHINT
This section describes how to play a song that has been recorded.
PAD ASSIGN
CAPACITY
ERASE OPTIMIZE
PLAY/STOP
RECORD
RE-SAMPLE
GRADE
MONO
STEREO
SAMPLING
EDIT 2
VOLUME/BASS
EXCITER
TREMOLO
AUTO PAN
LO-FI EFFECT
EXTREME EQ
COMPRESSOR
RESONANCE
HIGH-PASS
LOW- PASS
DISTORTION
RING MODULATOR
PITCH SHIFTER
DIMENSION
CHORUS
PHASER
FLANGER
STEP CRY
DELAY
REVERB
TIME STRETCH
SCRATCH
EFFECT
ON/OFF
PAD ENABLE
A
B
COPY DELETE
BACKUP
EXIT
SPECIAL
LOAD SAVE
INTERNAL/DATA CARD
+
AUTO SYNC
PLAYLIST
TAP
BPM
SONG
PLAY/STOPREC
BPM/
VALUE
MEASURE
SAMPLE/SONGBEAT
+
[–] [+] keys
SONG
PLAY/STOPREC
SONG
PLAY/STOPREC
In play mode, use the [-] [+] keys to select the song number (1 - 8).
1
STEP
Press the [SONG PLAY/STOP] key.
2
STEP
To stop the song, press the [SONG PLAY/STOP] key again.
3
STEP
+
SONG
PLAY/STOPREC
SPECIAL
You can also change the playback position of the song. While the song is stopped, hold
down the [SPECIAL] key and the press the [SONG PLAY/STOP] key.
4
STEP
+
[–] [+] keys
SONG
PLAY/STOPREC
Use the [-] [+] keys to specify the bar.
5
STEP
When you have specified the desired position, press the [SONG PLAY/STOP] key.
6
STEP
51
Creating Songs
Playing a Song
HINTHINT
Number of bars at playback start position
BPM/
VALUE
MEASURE
SAMPLE/SONGBEAT

Table of Contents

Related product manuals