Zoom Sampletrak ST-224 - Storing and Reading Data; Bulk Data Loading (Data Card)

If the indication "noCArd" appears, the data card is not recognized.
Check whether the card has been inserted properly.
Bulk data (all waveform data, pad parameter settings, song data for
internal sequencer) are copied from the data card into the main
memory. The ST-224 then returns to the regular play mode.
NOTE
Use the [-] [+] keys to select the number of the bulk data source file (1 - 99).
3
STEP
Press the [LOAD] key while the unit is in play mode.
1
STEP
63
Storing and Reading Data
BACKUP
LOAD SAVE
INTERNAL/DATA CARD
BACKUP
LOAD SAVE
INTERNAL/DATA CARD
BACKUP
LOAD SAVE
INTERNAL/DATA CARD
+–
[–] [+] keys
Use the [INTERNAL/DATA CARD] key to select "CArdXX" as load source. (XX is a file
number from 1 to 99.)
2
STEP
Press the [LOAD] key again.
4
STEP
SONG
PAD
FUNCTION
PAD ASSIGN
CAPACITY ERASE OPTIMIZE
PLAY/STOP RECORD
RE-SAMPLE GRADE
MONO
STEREO
SAMPLING
EDIT 2
EFFECT
ON/OFF
PAD ENABLE
A
B
EFFECT SYNC
EDIT 1
5
PRE COUNT
END POINT
3
TIME SIG
START POINT
1
BAR LENGTH
LEVEL
7
CLICK VOLUME
REVERSE
COPY DELETE
BACKUP
EXIT
SPECIAL
LOAD SAVE
INTERNAL/DATA CARD
+ –
AUTO SYNC
PLAYLIST
TAP
BPM
SONG
PLAY/STOPREC
BPM/ VALUE
MEASURE SAMPLE/SONGBEAT
Loading Bulk Data (Data Card)
This section explains how load bulk data stored on a data card SM04 (option) into the main memory.