Getting Connected
8
Getting Connected
Connections to Playback Equipment and MIDI Equipment
ZOOM CORPORATION
MADE IN JAPAN
MODEL
L/M
O
N
O
PHONES
R DATA CARD MIDI IN DC9V
300mA
POWER
OUTPUT
L/M
O
N
O
LINE/MIC
R
INPUT
DC INPUTPHONES
AC Adapter
(mixer, audio system, radiocassette player, etc.)
Playback equipment
MIDI OUT jack of MIDI sequencer or computer
with MIDI interface
HeadPhones
Data card (option)
OUTPUT L/MONO MIDI INOUTPUT R
For mono playback, only the
[OUTPUT L/MONO] jack
needs to be connected.
When wishing to synchronize
the operation of the ST-224
with an external sequencer or
control the sound of the ST-
224 sound from external
MIDI equipment, connect the
MIDI OUT jack of the
external equipment to the
[MIDI IN] jack of the ST-224,
using a MIDI cable.
ZOOM CORPORATION
MADE IN JAPAN
MODEL
L/M
O
N
O
PHONES
R DATA CARD MIDI IN DC9V
300mA
POWER
OUTPUT
L/M
O
N
O
LINE/MIC
R
INPUT
MAXMIN
INPUT
PEAK
INPUT
R MIC/LINEL/MONO
CD Player
INPUT L/MONO INPUT R
[INPUT PEAK] LED
[INPUT] knob
LINE/MIC
To sample a signal from equipment
with line-level output such as a CD
player, set the [LINE/MIC] switch
to the "LINE" position.
When sampling a stereo source, connect the [INPUT L/MONO]
jack and the [INPUT R] jack to the source. For mono sampling,
only the [INPUT L/MONO] jack needs to be connected. It is
also possible to mix a stereo source internally and perform
mono sampling (
➔
p. 21).
Adjust the [INPUT] knob so that
the [INPUT PEAK] LED on the
front panel lights up during the
loudest passages of the music.
Connection to Sound Source (1) (CD Player)
To Next Page
Loading...
