Zoom Sampletrak ST-224 - MIDI Application Example; Synchronizing Song Playback with External MIDI

While this setting is selected, song recording is not possible.
The ST-224 now is set up to receive the MIDI clock, song position
pointer, and start/stop/continue messages via the [MIDI IN] jack.
The ST-224 also begins playback.
HINTHINT
Song playback of the ST-224 can be synchronized to an external MIDI sequencer or rhythm machine.
BANK
3
BANK
2
BANK
SONG
PAD
1
FUNCTION
PAD ASSIGN
CAPACITY ERASE OPTIMIZE
PLAY/STOP RECORD
RE-SAMPLE GRADE
MONO
STEREO
SAMPLING
EFFECT
EDIT 2
VOLUME/BASS
EXCITER
TREMOLO
AUTO PAN
LO-FI EFFECT
EXTREME EQ
COMPRESSOR
RESONANCE
HIGH-PASS
LOW- PASS
DISTORTION
RING MODULATOR
PITCH SHIFTER
DIMENSION
CHORUS
PHASER
FLANGER
STEP CRY
DELAY
REVERB
TIME STRETCH
SCRATCH
EFFECT
ON/OFF
PAD ENABLE
A
B
EFFECT SYNC
EDIT 1
LOOP/MARK
4
SHIFT
OFFSET
6
SWING
PANNING
8
MIDI
TRIGGER/GATE
2
QUANTIZE
TUNING
SOURCE
SOURCE MIX
5
PRE COUNT
END POINT
3
TIME SIG
START POINT
1
BAR LENGTH
LEVEL
7
CLICK VOLUME
REVERSE
MAXMINMAXMIN
PEAK
COPY DELETE
BACKUP
EXIT
SPECIAL
LOAD SAVE
INTERNAL/DATA CARD
+ –
AUTO SYNC
PLAYLIST
TAP
BPM
SONG
PLAY/STOPREC
BPM/ VALUE
MEASURE SAMPLE/SONGBEAT
SONG
PAD
FUNCTION
+–
[–] [+] keys
Set the external equipment up so that it sends the MIDI clock, song position pointer, and
start/stop/continue messages.
1
STEP
Select the song at the ST-224 that you want to synchronize.
2
STEP
Press the [SONG FUNCTION] key and then pad 8 (MIDI).
3
STEP
Use the [-] [+] keys to call up the indication "Midi" on the display.
4
STEP
Press the [SONG FUNCTION] key again.
5
STEP
Give the start command from the external equipment.
6
STEP
Synchronizing Song Playback of the ST-224 With External Equipment
68
MIDI Application Example
SONG
PAD
FUNCTION
8
MIDI
TRIGGER/GATE