Zoom Sampletrak ST-224 - Pad Play Mode Operation; Clearing Pad Settings

35
Pad Play Mode Operation
The [DELETE] LED flashes and the bank number (1 - 3) and pad
number (1 - 8) of the pad to be deleted are shown on the display.
The settings for the pad are deleted. To cancel the delete process,
press the [EXIT] key instead of the [DELETE] key.
The settings for a given pad can be erased when no longer needed. When the settings for a pad are erased,
the sample reverts to the original (unassigned) condition.
BANK
3
BANK
2
BANK
SONG
PAD
1
FUNCTION
PAD ASSIGN
CAPACITY ERASE OPTIMIZE
PLAY/STOP RECORD
RE-SAMPLE GRADE
MONO
STEREO
SAMPLING
EDIT 2
VOLUME/BASS
EXCITER
TREMOLO
AUTO PAN
LO-FI EFFECT
EXTREME EQ
COMPRESSOR
RESONANCE
HIGH-PASS
LOW- PASS
DISTORTION
RING MODULATOR
PITCH SHIFTER
DIMENSION
CHORUS
PHASER
FLANGER
STEP CRY
DELAY
REVERB
TIME STRETCH
SCRATCH
EFFECT
ON/OFF
PAD ENABLE
A
B
EFFECT SYNC
EDIT 1
LOOP/MARK
4
SHIFT
OFFSET
6
SWING
PANNING
8
MIDI
TRIGGER/GATE
2
QUANTIZE
TUNING
SOURCE
SOURCE MIX
5
PRE COUNT
END POINT
3
TIME SIG
START POINT
1
BAR LENGTH
LEVEL
7
CLICK VOLUME
REVERSE
COPY DELETE
BACKUP
EXIT
SPECIAL
LOAD SAVE
INTERNAL/DATA CARD
+ –
AUTO SYNC
PLAYLIST
TAP
BPM
SONG
PLAY/STOPREC
BPM/ VALUE
MEASURE SAMPLE/SONGBEAT
Clearing Pad Settings
DELETE
BANK
1
BANK 1– 3 keys
Pads 1 – 8
DELETE
BPM/ VALUE
MEASURE SAMPLE/SONGBEAT
Bank number
Pad number
BPM/ VALUE
MEASURE SAMPLE/SONGBEAT
Use the [BANK 1] - [BANK 3] keys and the pads 1 - 8 to select the pad to delete.
2
STEP
Press the [DELETE] key.
1
STEP
Press the [DELETE] key again.
3
STEP