26
Fi to 5 GHz. The SSID for 5 GHz Wi-Fi will be the SSID for 2.4 GHz Wi-
Fi with a “_5G” suffix.
NOTE:
Scan the QR codes to connect to the 2.4 GHz or 5 GHz Wi-Fi.
Managing Guest SSID Settings
You can enable a guest SSID on the 2.4 GHz bands for temporary users to
connect with limited time for access and restriction to the 5G CPE web
pages.
Click the Enable/Disable to the right of Guest SSID and click Apply to turn
on or off the guest Wi-Fi. The Wi-Fi of the Smart Hub will restart. Then
configure the following options and click Apply.
NOTE:
Disable Internet Wi-Fi before you enable Guest SSID.
• Allow Guest SSID to access admin page: Allow or forbid users
connected to the guest SSID to access the 5G CPE web pages.
• Network name (SSID): Set the network name for the guest SSID.
• Broadcast network name (SSID): Only when you check this option can
new Wi-Fi clients find the network. If you want new clients to connect,
you must enter the SSID and password manually.
• Isolate all wireless devices: When you check this option, clients
connected to the guest Wi-Fi network cannot discover and communicate
with each other via the network.
• Security mode: Set the security mode for authentication and
encryption.
• Password: Set the Wi-Fi password when the security mode is not
OPEN.
NOTE:
Check the Show password box to view the password.
• Time limits for network access: Select the upper time limit for all
To Next Page
Loading...
