Zte MC889 - Detecting and Adjusting Installation Position

44
Detecting and Adjusting Installation Position
1. Move the device around the mounting wall/pole or try di󰀨erent positions and
touch
DETECT POSITION
.
2. Follow the on-screen instructions to attach the device to your target position,
and slowly move it until it provides feedback.
NOTE:
The device does not support elevation angle adjustment. It only supports
horizontal 180° adjustment.
3. The signal strength at the current position is displayed (Perfect, Great, Good,
Poor and Terrible). You can touch
view details
to view the network details.
When the device signal is detected, your phone automatically beeps. The
louder the sound and the stronger the vibration, the better the signal strength.
NOTE:
Touch
FINISH
to end the detection and select whether to save the current
position if needed.
4. Continue the detection until the desired position is detected, and save or
continue to adjust the position as prompted.
Powering o󰀨 the MC889
After the installation position is determined, disconnect the POE adapter from the
device.