32 33
• Shot Slot: To indicate that 802.11g is using a shot time slot
because there is no legacy station(802.11b) present.
• Tx Burst: Tx burst allows router to deliver better throughput in
the same period and environment in order to increase speed.
• Pkt_Aggregate: Increase efficiency by aggregating multiple
application packets data into a single transmission frame. In this
way, 802.11n networks can send multiple data packets with the
xed overhead cost in just a single frame.
• Country Code: Select the region you live.
The Wi-Fi multimedia parameters are shown below:
• WMM Capable: When multimedia contents are transferred
over wireless network, this function enhances data transfer
performance.
• APSD Capable: Automatic Power Save Delivery (APSD),enable
or disable data flow using APSD during transmitting for power
saving.
Click Apply to conrm your conguration.
Security
Select Wi-Fi Setting > Security, the Security parameters are shown
in the following gure:
Unless one of these encryption modes is selected, wireless trans-
missions to and from your wireless network can be easily intercept-
ed and interpreted by unauthorized users.
The security modes are described below:
• OPEN: You can authenticate successfully with a SSID, whether
it is valid or empty.
• SHARED: The WLAN clients who have the same WEP key with
wireless gateway can pass the authentication and access the
wireless network.
• WEPAUTO: Select WEP security automatically.
• WPA-PSK: WPA Pre-Shared Key, Enter the Pre-Shared key as a
plain text (ASCII) pass-phrase of at least 8 characters.
• WPA2-PSK: It is the securer version of WPA with implementation
of the 802.11i standard.
• WPA-PSK/WPA2-PSK: Apply both the WPA-PSK and WPA2-
PSK scheme.
If the Authentication type is SHARED, WEPAUTO, the bottom part
of the conguration page displays parameters as shown.
• WEP Keys: At most four keys can be set in the blank. Choose
the primary key index. The primary key is the only key in use at
a given time. Whatever keys you enter for an access point, you
must also enter the same keys for the client adapter in the same
order. In other words, WEP key 1 on the AP must match WEP
key 1 on the client adapter, WEP key 2 on the AP must match
WEP key 2 on the client adapter, etc. Select Hex if use 10 or 26
hexadecimal numbers (0~9, a~f or A~F). Select ASCII if use 5 or
13 ASCII characters (case-sensitive).
If the Authentication type is WPA-PSK, WPA2-PSK or WPA-PSK/
WPA2-PSK, the bottom part of the conguration page displays WPA
parameters.
• WPA Algorithm: TKIP, AES or AUTO.
• Pass phrase: You can input hexadecimal digits up to 64
characters or input ASCII characters choose a length of 63
characters or less.
MF29T User Manual V1.1-0703.indd 32-33 2012-7-3 16:46:32
To Next Page
Loading...
