Zte MF29 - Accessing the WebGUI Configuration Page; Login

30 31
5. Set peer AP's wire-
less MAC address on
router
Only Repeater Mode and Bridge Mode
need this.
The HT physical Mode parameters are shown below:
• Operating Mode: In Mixed Mode, packets are transmitted with
a preamble compatible with the legacy 802.11a/g, the rest of
the packet has a new format. In Green Field, high throughput
packets are transmitted without a legacy compatible part.
• Channel BandWidth: Set the HT physical channel bandwidth.
• Guard Interval: Guard interval is to introduce immunity to
propagation delays, echoes and reections, to which digital data
is normally very sensitive.
• MCS: The Modulation and Coding Scheme (MCS) is a value
that determines the modulation, coding and number of spatial
channels.
• Reverse Direction Grant(RDG): Enable RDG or not.
• Extension Channel: Set extension channel. Extension channel
is also able to send and receive data.
• Aggregation MSDU(A-MSDU) :To enable Hyper Throughput TX
Aggregate MAC Service Data Unit, select Enable.
• Auto Block ACK: Select to block ACK (Acknowledge Number)
or not during data transferring.
• Decline BA Request: Select to reject peer BA-Request or not.
Click Apply to conrm your conguration.
Advanced
Select Wi-Fi Setting > Advanced, the advanced wireless network
parameters are shown in the following gure:
• Beacon Interval: The router broadcasts beacon message to
announce that it has buffered frames to deliver. The default value
is 100 (ms).Beacons are packets sent by an access point to
synchronize a wireless network. Specify a beacon interval value.
is recommended.
• Data Beacon Rate(DTIM): A Delivery Traffic Indication
Message(DTIM) informs next clients to listen to broadcast and
multicast messages.
• Fragment Threshold: This value should remain at its default
value of 2346. If you experience a high packet error rate, you
may slightly increase your fragment threshold. Setting the
fragment threshold too low may result in poor performance.
• RTS Threshold: Request To Send (RTS) threshold should be
remained as the value of 2347. If you encounter inconsistent
data ow, only minor modications are recommended.
• TX Power: Transmit power should be remained as the value of
100.
• Short Preamble: The length of CRC block in the frames during
the wireless communication.
MF29T User Manual V1.1-0703.indd 30-31 2012-7-3 16:46:32