Zte MF60 - Led Indicator

ZTE MF60 Quick Guide
2 Confidential and Proprietary Information of ZTE CORPORATION
Right Side Front Left Side Bottom
Interface and Buttons
1.Power
Hold the Power button to switch on/off the
device.
2.Memory card slot (microSD card)
It is where you insert the memory card (microSD
card).
3.WPS
This button is used to start/end Wi-Fi Protected
Setup authentication process and enable/disable
the Wi-Fi function.
 Hold it for 3 seconds to activate the WPS
function.
 When the WPS function is available, press it to
deactivate the WPS function.
 Press it to enable/disable Wi-Fi function.
4. LED Screen
It indicates the signal type, signal strength,
battery, Wi-Fi, etc.
5. External Antenna Connector
It is used to connect an external antenna to
enhance the signal strength.
6.Charger/USB port
 Charge your device.
 Connect the client to your device via USB
cable.
Notes:
Hold the WPS and Power buttons simultaneously until the LED screen turns off, and then release the
buttons. The device will restart automatically and restore to the factory default settings.
Please use the original external antenna if necessary.
LED Indicator
When the device is powered on, the following icons will appear on the LED screen, with the
corresponding indicates listed in the table below:
Icon
Indication
Network signal strength.
Network type. 2G or 3G icon will appear on the LED screen according to the network