Zte WF820+ - Page 24

6. Set Security.
If Security is set to NONE (not recommended), Wi-Fi clients directly connect to the CPE.
This security level is low.
If Security is set to WEP, Wi-Fi clients connect to the CPE in web-based encryption mode.
If Security is set to WPA-PSK, Wi-Fi clients connect to the CPE in WPA-PSK encryption
mode.
If Security is set to WPA2-PSK, Wi-Fi clients connect to the CPE in WPA2-PSK
encryption mode. This mode is recommended because it has a high security level.
If Security is set to WPA-PSK & WPA2-PSK, Wi-Fi clients connect to the CPE in WPA-
PSK&WPA2-PSK encryption mode.
7. Set the encryption mode.
If…
Sets to
Description
WEP
Authentication mode
 Shared authentication: The client
connects to the CPE in shared
authentication mode.
 Open authentication: The client connects
to the CPE in open authentication mode.
 Both: The client connects to the CPE in
shared or open authentication mode.
Encryption password
length
 128bit: Only 13 ASCII characters or 26
hex characters can be entered in the Key 1
to Key 4 boxes.
 64bit: Only 5 ASCII characters or 10 hex
characters can be entered in the Key 1 to
Key 4 boxes.
Current
password index
This value can be set to 1, 2, 3, or 4. After a key
index is selected, the corresponding key takes
effect.
WPA-PSK
WPA-PSK
Only 8 to 63 ASCII characters or 8 to 64 hex
characters can be entered.
WPA encryption
This value can be set to TKIP+AES, AES, or
TKIP.
WPA2-
PSK(recommen
ded)
WPA-PSK
Only 8 to 63 ASCII characters or 8 to 64 hex
characters can be entered.
WPA encryption
This value can be set to TKIP+AES, AES, or
TKIP.
WPA-PSK &
WPA2-PSK
WPA-PSK
Only 8 to 63 ASCII characters or 8 to 64 hex
characters can be entered.
WPA encryption
This value can be set to TKIP+AES, AES, or
TKIP.
8. Click Submit. As shown in Figure 4-3.