USING THE WPS (OPTIONAL)
If your client device (cellphone, tablet, laptop, etc.) supports WPS, you don’t
have to input the password manually after WPS has been enabled. Please
complete the following steps:
1. Log into the Web UI by visiting http://192.168.0.1 or http://mobile.hotspot.
2. Select Settings > Wi-Fi Settings > Basic Settings to enable the Broadcast
Network Name (SSID) and to set the Security Mode.
3. Set a Wi-Fi password in WPA2 (AES)-PSK mode or WPA-PSK/WPA2-PSK
mode and then click Apply to confirm the settings.
4. Press and hold the WPS key to start the Wi-Fi Protected Setup
authentication process.
5. Enable the WPS function on your client device to respond to this
authentication process.
6. Follow the system prompts on your client device to finish the connection.
NOTE:
Refer to your specific client device's instruction manual for more detailed
information regarding WPS settings.
GETTING STARTED
12
To Next Page
Loading...
