ZXHN H1600 Maintenance Management Guide
Parameter Description
On Demand
Auto-disconnected without traffic Setting this parameter when Connection Mode is On De-
mand.
NAT Switch Select on/off NAT switch function.
5. On the main page of the ZXHN H1600, select Internet > Status > 3G to the 3G
Working Mode page, as shown in Figure 5-12.
Figure 5-12 3G Working Mode
6. Set the parameters and click Apply. For a description of the parameters, refer to Ta-
ble 5-5.
Table 5-5 3G Working Mode parameters
Parameter Description
3G Mode Enables or disables the 3G Working function.
Backup Interval Sets the interval after which services are switched to the
standby line when the active line is interrupted.
Recovery Primary Uplink Interval Sets the interval after which services are switched back to
the active line when the active line is recovered.
Result
On the main page of the ZXHN H1600, select Internet > Status > 3G to the 3G Con-
nection Status page, as shown in Figure 5-13.
5-16 SJ-20200218145027-006 | 2021-03-04(R1.0)
To Next Page
Loading...
