ZXHN H1600 Maintenance Management Guide
Steps
1. On the main page of the ZXHN H1600, select Internet > QoS > Congestion Man-
agement to open the Congestion Management page, see Figure 5-16.
Figure 5-16 Congestion Management
Table 5-7 lists the QoS congestion management parameters.
Table 5-7 QoS Congestion Management Parameters
Parameter Description
Queue Switch Select On to enable the function of queue.
Select Off to disable the function of queue.
Name To create a QoS congestion, enter the name of the congestion.
Priority Queue priority.
Range: 1 – 4.
Each queue has a priority, queue priority is higher, the lower the priority
value, and the SP queue priority value must be less than WRR queue.
Algorithm Options:
SP: Under the same interface, if a queue's algorithm is SP, its priority
must not be used by other queues.
DWRR: If there are four queues, and four weights, which are 100% in
total, can be configured for the queues, the packets for each queue
are sent according to open the corresponding weight.
Weight Weight value of the WRR/WFQ algorithm. If the weight values in the four
rules are respectively 6, 3, 2, 1, the bandwithd for the value of 3 is 3/
(6+3+2+1)=25%.
Traffic Classes Categorization mechanism.
5-20 SJ-20200218145027-006 | 2021-03-04(R1.0)
To Next Page
Loading...
