Zte ZXV10 T700 - Initial System Settings Configuration

Chapter1Overview
ConferenceControl
YoucanperformconferencecontrolovertheZXV10T700terminalthroughthefollowing
twomodes:GUIontheremotecontrolandPCconsole.
lPresstheConfkeyontheremotecontroltoperformconferencecontrol.
lLogintothePCconsoleoftheterminaltoperformconferencecontrol.
ConferenceInitiation
YoucaninitiateaconferencebyusingtheZXV10T700terminalthroughthefollowingthree
modes:GUIontheremotecontrol,Webpage,andPCconsole.
lPresstheCallkeyontheremotecontroltoinitiateaconference.
lVisithttp://IPaddressoftheterminalandinitiateaconferencebyselectingCall
Control>Call/Disconnect.
lLogintothePCconsoleoftheterminalandinitiateaconferencebyselectingCall
Control.
1.3ValidatingSettings
Afterthecongurationismodied,doasfollowstosaveandmakethesettingstakeeffect.
Prerequisite
Terminalcongurationcanbemodiedonlywhentheterminalsarenotinconference.
Steps
lDoasfollowstosavethemodicationbyusingtheremotecontrol:
a.Afterterminalinformationismodied,presstheReturnkeyontheremotecontrol.
Aconrmationdialogboxisdisplayed.
b.SelecttheOKbutton,andclicktheOKkeyontheremotecontrol.
lTosavethemodicationontheWebpage,clicktheOKbuttonatthelowerpartofthe
page.
–EndofSteps–
1.4SystemSettingsforFirstUsage
Duringtherstusageoftheterminalafterbeingmanufactured,thewizardofsystemsetting
promptsafterpower-on.
YoucanalsoselectSystem>SetupGuidetodisplaythesystemsettingwizard.
Prerequisite
lTheterminalandperipheralsareconnectednormallyandpoweredon.
lTheterminalisstarted.
1-3
SJ-20120112164919-002|2012-05-10(R1.1)ZTEProprietaryandCondential