EasyManua.ls Logo

ZyXEL Communications AMG1202-T10A - Wireless Features

ZyXEL Communications AMG1202-T10A
296 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 23 Product Specifications
AMG1202-T10A User’s Guide
220
23.3 Wireless Features
Other Protocol Support SIP pass-through
DNS Proxy
Dynamic DNS (www.dyndns.org)
IP Alias
DHCP client/server/relay
RIP I/ RIP II supported
Support 16 IP Static routes by Gateway
IGMP v1 and v2
IP Policy Routing
UPnP support
Transparent bridging, VLAN-tagging pass-through bridge mode
Static DHCP
Management Embedded Web Configurator(remove webhelp)
SNMP v1 & v2c with MIB II
Remote Management Control: Telnet, FTP, and Web.
TR-069 HTTPS
MTU adjustable on WebGUI
SMT
Table 94 Firmware Specifications (continued)
Table 95 Wireless Features
Internal Antenna The ZyXEL Device is equipped with one internal antenna to provide a
clear radio signal between the wireless stations and the access
points.
Wireless LAN MAC Address
Filtering
Your device can check the MAC addresses of wireless stations
against a list of allowed or denied MAC addresses.
WEP Encryption WEP (Wired Equivalent Privacy) encrypts data frames before
transmitting over the wireless network to help keep network
communications private.
Wi-Fi Protected Access Wi-Fi Protected Access (WPA) is a subset of the IEEE 802.11i
security standard. Key differences between WPA and WEP are user
authentication and improved data encryption.
WPA2 WPA 2 is a wireless security standard that defines stronger
encryption, authentication and key management than WPA.

Table of Contents

Other manuals for ZyXEL Communications AMG1202-T10A

Related product manuals