ZyXEL Communications Dimension ES-3124 - Monitor Status

Dimension ES-3124 Ethernet Switch
Introduction to CLI 28-5
Table 28-1 Command Summary: sys
COMMAND DESCRIPTION
cnt [value]
Sets (0-34463) or displays the
current watchdog count (in 1.6 sec
units).
monitor status
Displays the status of the hardware
monitor.
show
Displays the hardware monitor’s
statistics.
vlimit <idx> <high> <low>
Sets the maximum (<high>) or
minimum (<low>) voltage at the
specified point (<idx>).
tlimit <idx> <limit>
Sets the maximum (<limit>)
temperature at the specified point
(<idx>).
flimit <bank> <idx> [<limit>]
Sets the maximum (<limit>) fan
revs per minute (RPM) at the
specified fan (<idx>) in the
specified bank (<bank>). A “bank”
delineates a set of fans.
fanmask <bank> [<mask>]
Sets the fan detection mask in the
specified bank (<bank>). Use the
mask to disable monitoring of a
fan.
vclear
Clears the voltage statistics.
tclear
Clears the temperature statistics.
fclear
Clears the fan statistics.
clear
Clears the hardware monitor
statistics.
enable [<on/off>]
Enables or disables the hardware
monitor.
test
Tests the hardware monitor chip.
addr
Displays the W83782D ISA bus
address.
hw-ver
Displays the hardware version ID.
socket
Displays the system socket’s ID #,
type, control block address (PCB),
IP address and port number of
peer device connected to the
socket (Remote Socket) and task
control block (Owner).
snmp getCommunity <index>
[<community>]
Sets or displays the SNMP
GetRequest community.
setCommunity <index>
[<community>]
Sets or displays the SNMP
SetRequest community.