Dimension ES-3124 Ethernet Switch
6-10 Basic Setting
Table 6-4 IP Setup
LABEL DESCRIPTION
IP Address Enter the IP address of your switch in dotted decimal notation for example 192.168.1.1.
IP Subnet Mask Enter the IP subnet mask of your switch in dotted decimal notation for example 255.255.255.0.
Default Gateway Enter the IP address of the default outgoing gateway in dotted decimal notation, for example
192.168.1.254.
Management
VID
Enter the VLAN identification number associated with the switch IP address. Management VLAN
ID is the VLAN ID of the CPU and is used for management only. The default is "1". All ports, by
default, are fixed members of this "management VLAN" in order to manage the device from any
port. If a port is not a member of this VLAN, then users on that port cannot access the device. To
access the switch make sure the port that you are connected to is a member of Management
VLAN.
Out-of-band
Management IP
Address
IP Address Enter the IP address of your switch in dotted decimal notation for example 192.168.0.1.
If you change this IP address, make sure the computer connected to this management port is in
the same subnet before accessing the ES-3124.
IP Subnet Mask Enter the IP subnet mask of your switch in dotted decimal notation for example 255.255.255.0.
Default Gateway Enter the IP address of the default outgoing gateway in dotted decimal notation, for example
192.168.0.254.
Apply Click Apply to save your changes back to the switch.
Cancel Click Cancel to begin configuring the fields again.
6.8 Port Setup
Click Basic Setting and then Port Setup in the navigation panel to enter the port configuration screen. You may
configure any of the switch ports.
To Next Page
Loading...
