ZyXEL Communications Dimension ES-3124 - Exit Command; Ip Commands; Table 28-3 Command Summary: Exit; Table 28-4 Command Summary: Ip

Dimension ES-3124 Ethernet Switch
28-14 Introduction to CLI
Table 28-2 Command Summary: sys sw
COMMAND DESCRIPTION
vlanstack set [enable|disable]
Enables or disables VLAN
stacking on the switch.
display
Displays whether VLAN stacking
is active.
tpid [value(Hex)]
Sets a tag protocol identifier
(TPID).
mode <port|portNo>
<mode=normal|access|tunnel> <spvid>
<pri(0-7)>
Sets VLAN stacking.
sfp disp
Shows sfp (mini GBIC port)
connection status.
info <index> <offset> <len>
Shows sfp (mini GBIC port)
connection information.
diag <index> <offset> <len>
This command is for testing.
28.2.3 exit Command
Table 28-3 Command Summary: exit
COMMAND DESCRIPTION
exit
Ends the console or telnet
session.
28.2.4 ip Commands
Table 28-4 Command Summary: ip
COMMAND DESCRIPTION
ip
address [addr]
Displays the host IP address.
alias <iface>
Sets an alias for the specified
interface.
aliasdis <0|1>
Disables/enables the alias for the
specified interface.
arp status
Displays all interfaces’ IP Address
Resolution Protocol status.
add <hostid> ether <ether
addr>
A
dd an IP address of a device with
corresponding MAC address.
drop
Removes an entry from the ARP
table.
flush
Deletes all entries from the ARP
table.