ZyXEL Communications Dimension ES-3124 - Page 195

Dimension ES-3124 Ethernet Switch
Introduction to CLI 28-13
Table 28-2 Command Summary: sys sw
COMMAND DESCRIPTION
display
Displays address learning status.
isolate
disable
Disables port isolation.(All
connected)
port <port> <Port-List (in Hex)>
Sets the port-list which can
connected to the specific port.
enable
Enables port isolation.
mc
set <addr> <port>...
Sets ports to a specific multicast
address.
del <addr>
Deletes a specific multicast
address.
get <addr>
Shows settings of the multicast
address.
vlan
status
Displays VLAN status.
type <802.1q | port-based>
Sets VLAN mode.
ffp table
Shows a summary of rule
settings.
dump <idx>
Removes the specified rule.
port <portID> <enable|disable> <auto,
10H, 10F, 100H, 100F, 1000>
<FlowControl=0/1>
Port setup.
portstatus
Displays current port status and
settings.
pktcnt <port>
Displays port statistic counter.
pktcntclear <port>
Resets port statistic counter.
policy add <policy name> <classifier name>
[deny] [forward] [setpriority
<priority>] [sendcos <priority>]
[movepriototos][settos <tos>]
[movetostoprio] [setdscp
<dscp>][sendmirror] [sendport
<port>] [sendnonunicasttoport
<port>] [setvid <vid>][meter
<bandwidth>] [meterout
<drop|setdscp|forward> <dscp>]
Adds a new policy rule.
del <policy name>
Removes a policy rule.
display
Displays the policy rule summary
table.
view <policy name>
Displays detail information of a
policy rule.