ZyXEL Communications Dimension ES-3124 - Page 194

Dimension ES-3124 Ethernet Switch
28-12 Introduction to CLI
Table 28-2 Command Summary: sys sw
COMMAND DESCRIPTION
enable
Turns on port mirroring
remove <port=all|portNo>
Removes mirrored port from the
mirroring group.
add <port=all|portNo>
<direction=ingress|egress|both>
Sets the mirrored port and
direction.
disable
Turns off port mirroring.
display
Displays current run-time port
mirror settings.
port <port>
Sets the mirror port (the port
traffic is copied to for analysis).
bw
The following commands relate
to bandwidth control rules.
Bandwidth control means
defining a maximum allowable
bandwidth for traffic flows from
specified source(s) to specified
destination(s).
display
Displays current run-time
bandwidth control rules.
set <port> <enable|disable> <ingress
rate[Mbps]> <egress rate[Mbps]>
Enables or disables bandwidth
control of ingress and/or egress
rates on individual ports.
trunk
The following commands relate
to trunking. Trunking is the
grouping of physical ports into
one logical higher-capacity link.
del <id>
Delete a trunk group.
display
Displays current run-time trunk
settings.
listview
Displays member list of trunk.
set <id> <# of port>
Adds ports to a trunk group.
ingress
set <port> <enable | disable>
Sets ingress check on a port.
get <port>
Gets ingress check state on a
port.
viewAll
Gets ingress check state on all
ports.
learn
enable
Enables address learning on the
switch.
disable
Disables address learning on the
switch.