Dimension ES-3124 Ethernet Switch
Introduction to CLI 28-17
Table 28-4 Command Summary: ip
COMMAND DESCRIPTION
dhcp <iface> status
Shows whether an interface can
accept information from a DHCP
server.
dhcp <iface> client release
Releases DHCP information such
as the IP address from an
interface
dhcp <iface> client renew
Renews the IP address on the
interface.
28.2.5 ether Command
Table 28-5 Command Summary: ether
COMMAND DESCRIPTION
config
Shows Ethernet configuration.
driver cnt disp <name>
Displays the channel of Ethernet driver.
ioctl <ch-name> <command>
[arguments]
status <ch-name>
Displays the channel status of Ethernet driver.
length <ch-name> [length]
Displays the channel length of Ethernet driver.
version
Displays the Ethernet version.
28.2.6 config Command
Table 28-6 Command Summary: config
COMMAND DESCRIPTION
config save
You can use the “config save” command to save 802.1Q, STP, VLAN
Stacking, Cluster and IP configuration changes to non-volatile memory
(Flash). These changes are effective after you restart the switch.
However you cannot use “config save” for all other line command
configurations. These are saved in volatile memory (DRAM), so are not
effective after you restart the switch.
To Next Page
Loading...
