ES-2024A User’s Guide
118 Chapter 21 Maintenance
7 Enter quit to exit the ftp prompt.
21.7.3 GUI-based FTP Clients
The following table describes some of the commands that you may see in GUI-based FTP
clients.
21.7.4 FTP over WAN Restrictions
FTP over WAN will not work when:
• Telnet service is disabled in Secured Client Sets.
• The IP address(es) in the Secured Client Sets menu does not match the client IP address.
If it does not match, the switch will disconnect the Telnet session immediately.
General Commands for GUI-based FTP Clients
COMMAND DESCRIPTION
Host Address Enter the address of the host server.
Login Type Anonymous.
This is when a user I.D. and password is automatically supplied to the server
for anonymous access. Anonymous logins will work only if your ISP or service
administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer Type Transfer files in either ASCII (plain text format) or in binary mode.
Configuration and firmware files should be transferred in binary mode.
Initial Remote Directory Specify the default remote directory (path).
Initial Local Directory Specify the default local directory (path).
To Next Page
Loading...
