ES-2024A User’s Guide
Chapter 4 The Web Configurator 43
4.3.1 Change Your Password
After you log in for the first time, it is recommended you change the default administrator
password. Click Management, Access Control and then Logins to display the next screen.
Port
Authentication
This link takes you to a screen where you can configure RADIUS (Remote
Authentication Dial-In User Service), a protocol for user authentication that allows
you to use an external server to validate an unlimited number of users.
Port Security This link takes you to a screen where you can activate MAC address learning and
set the maximum number of MAC addresses to learn on a port.
Queuing Method This link takes you to a screen where you can configure SPQ or WFQ with
associated queue weights for each port.
IP Application
Static Route This link takes you to screens where you can configure static routes. A static route
defines how the switch should forward traffic by configuring the TCP/IP parameters
manually.
DiffServ This link takes you to screens where you can enable DiffServ and set DSCP-to-
IEEE802.1p mappings.
Advanced
Management
Maintenance This link takes you to screens where you can perform firmware and configuration
file maintenance as well as reboot the system.
Access Control This link takes you to screens where you can change the system login password
and configure SNMP and remote management.
Diagnostic This link takes you to screens where you can view system logs and test port(s).
Cluster
Management
This link takes you to a screen where you can configure clustering management
and view its status.
MAC Table This link takes you to a screen where you can view the MAC addresses (and types)
of devices attached to what ports and VLAN IDs.
ARP Table This link takes you to a screen where you can view the MAC addresses – IP
address resolution table.
Routing Table This link takes you to a screen where you can view the routing table in the switch.
Table 5 Navigation Panel Links (continued)
LINK DESCRIPTION
To Next Page
Loading...
