ZyXEL Communications ES-2024A - Show Ip; Show Logging; Figure 100 Show Ip Command Example; Figure 101 Show Logging Command Example

ES-2024A User’s Guide
168 Chapter 28 Command Examples
28.2.2 show ip
Syntax:
show ip
This command displays the IP related information (such as IP address and subnet mask) on all
switch interfaces.
The following figure shows the default interface settings.
Figure 100 show ip Command Example
28.2.3 show logging
Note: This command is not available in User mode.
Syntax:
show logging
This command displays the system logs. The following figure shows an example.
Figure 101 show logging Command Example
Note: If you clear a log (by entering y at the Clear Error Log (y/n):prompt), you
cannot view it again.
ras> show ip
IP Interface
IP[192.168.1.24], Netmask[255.255.255.0], VID[1]
ras>
ras# show logging
0 Thu Jan 1 00:00:11 1970 PP2b INFO adjtime task pause 1 day
7 Thu Jan 1 01:06:26 1970 PP23 ERROR ospfReadConf: can't get spOSPFArea_t
10 Thu Jan 1 01:06:38 1970 PP23 ERROR ospfReadConf: can't get spOSPFArea_t
13 Thu Jan 1 01:06:50 1970 PP23 ERROR ospfReadConf: can't get spOSPFArea_t
16 Thu Jan 1 01:07:05 1970 PP23 ERROR ospfReadConf: can't get spOSPFArea_t
20 Thu Jan 1 00:00:04 1970 PP0c -WARN SNMP TRAP 3: link up
21 Thu Jan 1 00:00:06 1970 PINI -WARN SNMP TRAP 1: warm start
22 Thu Jan 1 00:00:06 1970 PINI -WARN SNMP TRAP 3: link up
22 Thu Jan 1 00:00:06 1970 PINI -WARN SNMP TRAP 3: link up
24 Thu Jan 1 00:00:07 1970 PP23 ERROR ospfReadConf: can't get spOSPFArea_t
25 Thu Jan 1 00:00:11 1970 PP2b INFO adjtime task pause 1 day
30 Thu Jan 1 00:00:04 1970 PP0c -WARN SNMP TRAP 3: link up
31 Thu Jan 1 00:00:06 1970 PINI -WARN SNMP TRAP 1: warm start
32 Thu Jan 1 00:00:06 1970 PINI -WARN SNMP TRAP 3: link up
Clear Error Log (y/n):