ZyXEL Communications G-202 - Access Point Mode Setup Example; Configuring the Computer on Which You Install the G-202

ZyXEL G-202 User’s Guide
Appendix B Access Point Mode Setup Example 87
APPENDIX B
Access Point Mode Setup Example
This example uses the network sharing feature in Windows 2000 to bridge the wired and
wireless network when you set the G-202 in access point (AP) mode.
Refer to Chapter 5 on page 73 for setup methods and requirements.
Steps may vary depending on your Windows version. You may need to install additional
software in Windows 98 Second Edition and Windows ME.
Configuring the Computer on Which You Install the G-202
1 Refer to Section 1.2.4 on page 23 to set the G-202 to operate in AP mode.
2 Click Start, Settings, Network and Dial-up Connections (or click Start, Settings,
Control Panel and double-click Network and Dial-up Connections).
Figure 54 Windows 2000: Start
3 Right-click on the icon for your wired Ethernet adapter and click Properties.