Chapter 22 SNMP
GS1510 Series User’s Guide
140
22.6 Trap Receiver
Use the Trap Receiver screen to enable the sending of SNMP traps to a remote
SNMP management station(s). Click Management > SNMP > Trap Receiver to
view the screen as shown.
SNMP traps are used to send out SNMP notifications of urgent or normal events in
the system to external management stations.
Figure 80 Trap Receiver
The following table describes the labels in this screen.
Rights This field displays the community string’s rights. This will be Read Only
or Read Write.
Network ID of
Trusted Host
This field displays the IP address of the remote SNMP management
station after it has been modified by the subnet mask.
Subnet Mask This field displays the subnet mask for the IP address of the remote SNMP
management station.
Action Click Delete to remove a specific Community String.
Table 45 Community Name (continued)
LABEL DESCRIPTION
Table 46 Trap Receiver
LABEL DESCRIPTION
IP Address Enter the IP address of the remote trap station in dotted decimal
notation.
Version Select the version of the Simple Network Management Protocol to use. v1
or v2c.
Community
String
Specify the community string used with this remote trap station.
Apply Click this to save any changes to the Switch.
Refresh Click this to reset the contents of the text boxes.
Trap Rece iver
List
To Next Page
Loading...
