Chapter 7 Broadband
Nebula Mobile Router User’s Guide
116
Note: This feature is only available on certain models.
Figure 65 Network Setting > Broadband > Cellular APN
The following table describes the labels in this screen.
7.5.1 Edit Cellular APN1/APN2
On the Cellular APN screen, click the Edit icon next to an APN to configure its settings.
Note: The IP Passthrough fields are not available for models that support the Network Setting >
Broadband > Cellular IP Passthrough screen.
Note: APN information can be obtained from your cellular service provider.
Note: Automatic mode is not supported in all cellular modes.
Table 30 Network Setting > Broadband > Cellular APN
LABEL DESCRIPTION
APN Settings
# This is the number of an individual APN.
Enable This field indicates whether the APN is enabled or disabled.
Mode This shows Auto when the Zyxel Device configures the APN (Access Point Name) of a
cellular network automatically.
This shows Manual when the APN is entered manually.
APN This shows the Access Point Name (APN).
Auth Type This shows PAP (Password Authentication Protocol) when peers identify themselves
with a user name and password.
This shows CHAP (Challenge Handshake Authentication Protocol) when additionally
to a user name and password, the Zyxel Device sends regular challenges to make
sure an intruder has not replaced a peer.
This shows PAP/CHAP when either type of authentication can be used.
This shows None when no authentication is used.
PDP Type This shows IPv4 when the Zyxel Device runs IPv4 (Internet Protocol version 4
addressing system) only.
This shows IPv4/IPv6 when the Zyxel Device runs IPv4 and IPv6 (Internet Protocol
version 4 and 6 addressing system) at the same time.
VLAN ID This shows the VLAN ID for the APN.
Modify Click the Edit icon to change the APN settings.
To Next Page
Loading...
