Chapter 28 User Account
Nebula Mobile Router User’s Guide
275
28.2.1 User Account Add or Edit
Add or change the name of the user account, set the security password and the retry times, and
whether this user will have Administrator or User privileges.
Click Add New Account or the Edit icon of an
existing account in the Maintenance > User Account to open the following screen.
Figure 180 Maintenance > User Account > User Account Add
The following table describes the labels in this screen.
Modify Click the Edit icon to configure the entry.
Click the Delete icon to remove the entry.
Cancel Click Cancel to restore your previously saved settings.
Apply Click Apply to save your changes.
Table 118 Maintenance > User Account (continued)
LABEL DESCRIPTION
Table 119 Maintenance > User Account > User Account Add/Edit
LABEL DESCRIPTION
Active Click to enable (switch turns blue) or disable (switch turns gray) to activate or deactivate the
user account.
User Name Enter a new name for the account (up to 15 characters). Special characters are allowed except
the following: double quote (") back quote (`) apostrophe or single quote (') less than (<) greater
than (>) caret or circumflex accent (^) dollar sign ($) vertical bar (|) ampersand (&) semicolon
(;)
Verify Password Enter the new password again for confirmation.
Retry Times Enter the number of times consecutive wrong passwords can be entered for this account. 0
means there is no limit.
Idle Timeout Enter the length of inactive time before the Zyxel Device will automatically log the user out of the
Web Configurator.
Lock Period Enter the length of time a user must wait before attempting to log in again after a number of
consecutive wrong passwords have been entered as defined in Retry Times.
To Next Page
Loading...
