Chapter 2 Hardware Panels
Nebula Mobile Router User’s Guide
32
The following table describes the ports and buttons on your Nebula LTE3301-PLUS.
2.3.2 Nebula LTE7461-M602
Figure 13 Nebula LTE7461-M602
The following table describes the ports and buttons on your Nebula LTE7461-M602.
Table 9 Nebula LTE3301-PLUS Panel Ports and Buttons
LABELS DESCRIPTION
ANT1-ANT2 Install the external antennas to strengthen the cellular signal.
LAN/Ethernet Connect a computer to the LAN using an RJ45 cable.
WiFi Press the WLAN (WiFi) button for more than 5 seconds to enable WiFi.
WPS After WiFi is enabled, press the WLAN button for more than one second but less than 5
seconds to quickly set up a secure wireless connection between the Zyxel Device and
a WPS-compatible client.
RESET Press the button for more than 5 seconds to return the Zyxel Device to the factory
defaults.
POWER Button Press the POWER button after the power adapter is connected to start the Zyxel Device.
POWER / DC IN Connect the power adapter and press the POWER button to start the Zyxel Device.
Reboot Press the RESET button for more than 2 seconds but less than 5 seconds, it will cause the
system to reboot.
SIM card Insert a micro-SIM card into the slot with the chip facing down and the beveled corner
in the top left corner.
Table 10 Nebula LTE7461-M602 Panel Ports and Buttons
LABELS DESCRIPTION
LAN (PoE) Connect a computer through the PoE injector for configuration.
Connect the PoE injector to a power outlet to start the device.
WiFi Press the WLAN (WiFi) button for more than 5 seconds to enable WiFi.
WPS After WiFi is enabled, press the WLAN button for more than one second but less than
5 seconds to quickly set up a secure WiFi connection between the Zyxel Device and
a WPS-compatible client.
RESET Press the button for more than 5 seconds to return the Zyxel Device to the factory
defaults.
SIM card Insert a micro-SIM card into the slot with the chip facing down and the beveled
corner in the top left corner.
To Next Page
Loading...
