Chapter 1 Get to Know Your NR2101
NR2101 User’s Guide
19
The following table describes the labels in this screen.
Note: You must activate WPS on the NR2101 and on another device within 2 minutes of each
other.
1.5.6.2 WiFi 2.4G
To enable a wireless client to connect to the 2.4GHz WiFi band, select WiFi Enable.
•Tap Bandwidth to select the 2.4G bandwidth (20MHz or 20/40 MHz) from the list. Tap the check mark
at the upper-right corner to save the change made.
Figure 13 2.4G WiFi bandwidth
•Select WiFi PMF to improve security for the wireless connection (WiFi PMF will not be available when
WPA3/WPA2 mixed mode is selected in the Security Type field).
Figure 14 2.4G WiFi PMF
Table 5 WPS
LABEL DESCRIPTION
WPS Use this to establish a WPS connection.
WPS PIN Type the WPS password to enable wireless clients to connect to the NR2101.
To Next Page
Loading...
