Chapter 7 WLAN & WWAN
NR2101 User’s Guide
62
See the rest of this chapter for information on the other labels in this screen.
7.2.1 Wireless Security
Use this screen to select the wireless security mode for the 2.4G/5G wireless LAN.
7.2.1.1 No Security
Select None (Open) to allow wireless clients to communicate with the access points without any data
encryption.
Note: If you do not enable any wireless security on your NR2101, your network is accessible to
any wireless networking device that is within range.
SSID SETTINGS (5G)
WiFi Enable Select this to enable or disable WiFi.
SSID The SSID (Service Set IDentity) is the name of the wireless network. Wireless clients use
the SSID to identify and connect to the NR2010. Enter a descriptive name (up to 32
printable characters found on a typical English language keyboard) for the wireless
LAN.
Hide SSID Select this check box to hide the SSID in the outgoing beacon frame so a station
cannot obtain the SSID through scanning using a site survey tool.
Password Type a password (of up to 8-64 characters including spaces and special characters)
the wireless stations need to enter to connect to the wireless network.
Security Type Select WPA-PSK, WPA2-PSK or WPA3/WPA2 mixed mode to add security on this
wireless network. The wireless clients which want to associate to this network must
have same wireless security settings as this device. See Section 7.2.1 on page 62 for
detailed information on different security modes. Or you can select None (Open) to
allow any client to associate this network without authentication.
Bandwidth Set the operating frequency/channel depending on your particular region. Choices
are 20M, 20/40M, or 20/40/80M.
Select a channel from the drop-down list box. The options vary depending on the
frequency band and the country you are in.
Table 23 SSID SETTINGS (2.4G/5G) (continued)
LABEL DESCRIPTION
To Next Page
Loading...
