Chapter 7 WLAN & WWAN
NR2101 User’s Guide
61
Figure 53 SSID SETTINGS(2.4G/5G)
The following table describes the labels in this screen.
Table 23 SSID SETTINGS (2.4G/5G)
LABEL DESCRIPTION
SSID SETTINGS (2.4G)
WiFi Enable Select this to enable or disable WiFi.
SSID The SSID (Service Set IDentity) is the name of the wireless network. Wireless clients use
the SSID to identify and connect to the NR2010. Enter a descriptive name (up to 32
ASCII characters, including spaces and special characters) for the wireless LAN.
Hide SSID Select this check box to hide the SSID in the outgoing beacon frame so a station
cannot obtain the SSID through scanning using a site survey tool.
Password Type a password (of up to 8-64 characters including spaces and special characters)
the wireless clients need to enter to connect to the wireless network.
Security Type Select WPA-PSK, WPA2-PSK or WPA3/WPA2 mixed mode to add security on this
wireless network. The wireless clients which want to associate to this network must
have same wireless security settings as this device. See Section 7.2.1 on page 62 for
detailed information on different security modes. Or you can select None (Open) to
allow any client to associate this network without authentication.
Bandwidth Set the operating frequency/channel depending on your particular region. Choices
are 20M or 20/40M.
Select a channel from the drop-down list box. The options vary depending on the
frequency band and the country you are in.
To Next Page
Loading...
